ARSET SA 40

ARSET SA 40 is used as an accelerator additive in concrete chemicals. It increases early strength without adversely affecting the final strength of concrete.

Request Product Information

Technical profile

Material data,
at a glance.

Key properties and declared technical characteristics for product selection and initial evaluation.

Chemical Base: Sulfoamine based
Color / Appearance: Brown liquid
pH: 10,50 – 12,50
Density: 1,21 ± 0,03 g/cm3
Chlorine Content (%): <0,1 (EN 480-10)
Alkaline Content (%): <10,0 (EN 480-12)
Corrosion Behavior: Contains only components according EN 934-1 Annex A.1
Dangerous Substances: Comply with annex AZ

Performance

Product advantages

It is used with normal and superplasticizers. However, it is not recommended to be used with additives that have a retarding effect.
Depending on the cement type and the temperature of the product, it significantly increases the early strength of the material in the first 24 hours.
Do not contain chloride or any other components that result in corrosion in the reinforcements. Therefore, it is suitable for use in reinforced concrete structures.

Application range

Areas of use

In the production of concrete and mortar where early high strength is required
Concrete and mortar applications in cold weather conditions
In cement and gypsum-based products where early strength is required

Use guidance

From selection
to application.

Application

ARSET SA 40 can be added to the mixing water or added to fresh concrete before discharge at the construction site. In this case, it will be sufficient to extend the mixing time for 1-2 minutes in order for the concrete mixture to be homogeneous.

Dosage

It is used at a ratio of 1.0-2.5% of the total mass. Optimum utilization rate should be determined according to laboratory trials.

Specification & supply

Standards, formats
and handling.

Standards

Arset SA 40 TS EN 934-2

Packaging

30 kg plastic drum
250 kg drum
Arstep / Arstep Extra/ Degaset Series Admixtures
Arset Air Series
Arset Doz
Arset Zero Series
1000 kg container

Storage

Shelf life is 12 months from the date of production when stored in original unopened and undamaged packages (drums, barrels, IBC containers) at temperatures between +5 °C and +35 °C, protecting from direct sunlight, excessive heat and frost. If the product has waited for a long time, make it homogeneous by mixing slowly at low speed with mechanical methods before using the product. Some subsidence may occur during long-term storage. In this case, the product can be used by filtering. Make sure that the product does not freeze. If the product freezes, it should be thawed by keeping it at room temperature without using direct heat and mixed by mechanical methods until it becomes homogeneous.